This was a super simple project that just took 30 minutes to do. In the end I had storage shelves, rods for ribbon storage and a few fabric covered bins to contain my supplies.
– wood glue – wood screws – ¾" panel board – 1x2x8' pine board – sand paper – tension rods
The first thing I did was measure the inside of the armoire to determine where my shelves would go.
Once the supports were cut, I checked to make sure they would fit, then drilled a pilot hole in each end for the wood screws.
Then I spread some wood glue on the back of each support and screwed them in place in the cabinet.